Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
Initial setting (operation setting)
Set the items for the operating method depending on the projector's application and duration of usage.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP]
menu → [OPERATION SETTING]. If you change the settings while using the projector, the duration until the
brightness decreases to half may shorten or the brightness may decrease.
This initial setting (operation setting) is prepared to complete the settings simply at once during the installation
when the operation of the projector is predetermined. This cannot set all the items regarding the operation setting.
When the detailed setting is required or setting change is required, ask the person responsible for this projector
(such as a person in charge of equipment or operation).
Note
f For the relationship between the brightness and the runtime, refer to "Relationship between brightness and runtime" (x page 77).
f For details on each setting item, refer to the [PROJECTOR SETUP] menu → [OPERATION SETTING].
1)
Press as to select [OPERATING MODE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[ECO]
[QUIET]
[USER1]
[USER2]
[USER3]
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
The value of runtime is just an estimate, and is not the warranty period.
3)
Press as to select [LIGHT OUTPUT].
4)
Press qw to adjust.
Operation
Press w.
Press q.
*1 The upper limit of the adjustment range is the value set in the [PROJECTOR SETUP] menu → [OPERATION SETTING] → [MAX LIGHT
OUTPUT LEVEL].
5)
Press the <ENTER> button to proceed to the initial setting.
76 - ENGLISH
INITIAL SETTING
OPERATING MODE
LIGHT OUTPUT
Set the way to use the projector. For details, please
refer to the operating instructions "When the initial
setting screen is displayed".
MENU SELECT
SET
ENTER
Set this item when high luminance is required. The estimated runtime is approximately 20 000 hours
or more
.
*1
The brightness will decrease compared to [NORMAL], but set this item to prioritize the life of the light
source. The estimated runtime is approximately 24 000 hours or more
The brightness will decrease compared to [NORMAL], but set this item to prioritize the operation with
low noise. The estimated runtime is approximately 20 000 hours or more
Set [LIGHT OUTPUT] as desired.
Adjustment
Brightness
The screen becomes brighter.
The screen becomes darker.
2/7
NORMAL
100.0%
CHANGE
dust.
3
Runtime
The runtime becomes shorter.
The runtime becomes longer.
.
*1
.
*1
Range of adjustment
8.0 % - 100.0 %
*1
Advertisement
Table of Contents
