RadioLink RC8X Instruction Manual page 63

trigger. The blink speed and trigger mode can be customized.
CPS mixing1/2/3/4
Mixing: The button at the right of "Mixing" is OFF, and the
background color of the select box is grey, indicating that the CPS
mixing function is turn off. The button at the right of "Mixing" is
ON, and the background color of the select box is blue, indicating
that the CPS mixing function is turn on.
Trigger CH: set the channel as the trigger channel to turn on
or turn off the CPS mixing function. Channel 1 to channel 8 can be
selected.
Operation CH: the channel to connect the light, channel 1 to
channel 8 can be selected. When press the switch that controlled
the light trigger channel, the light or turn on or turn off. The
operation channel can set same channel as the trigger channel.
Trigger mode: Neutral, Left, Right, Both sides, PS switch can be selected according to the
trigger switch you have set.
Point1/2: the rudder amount to trigger the light turn on or turn off.
Operation mode: off till triggered to flash, flash till triggered to off, off till triggered to on,
and on till triggered to off can be selected.
Off till triggered to flash: the LEDs will keep off till the trigger
switch reach the point value you have set that trigger the LEDs
flash. The LEDs will keep flash until you trigger the LED to off.
Flash till triggered to off: the LEDs will keep flash till the
trigger switch reach the point value you have set that trigger the
LEDs off.
Off till triggered to on: the LEDs will keep off till the trigger
switch reach the point value you have set that trigger the LEDs
turn on. The LEDs will keep on until you trigger the LED to off.
On till triggered to off: the LEDs will keep on till the trigger
switch reach the point value you have set that trigger the LEDs
turn off.
Cycle speed: When "Operation mode" is set to "Flash", the "Cycle speed" can be set to
change the LEDs' flash speed. It defaults 50, 1 to 100 can be selected, the smaller the value, the
faster the LEDs flash.
Point1/2: beside make the trigger switch reach the point value you have set (the point value
set below the Trigger mode), point 1 and point2 below the "Cycle speed" must set to trigger
the LEDs operation. The value of Point1 is default 0 and the value of Point2 is default 100, the
absolute value of Point1 plus the absolute value of Point2 do not less than 95. The details value
must depend on your LEDs.
62
RadioLink Electronic Limited
www.radiolink.com