Racing Curve; Steering Curve - RadioLink RC8X Instruction Manual

to turn on the sensor status and time broadcast automatically function. If both the sensor status
and time broadcast automatically function are turned on, they will broadcasted according to the
order list of the menu.
Broadcast interval: the interval period for broadcast, if the sensor status and time broadcast
automatically function has turned on, it defaults alarm once every 1 minute, the alarm interval
time can be customized.

2.5 Racing curve

2.5.1 Steering curve

This function is used to change the sensitivity of the steering servo around the neutral
position. It has no effect on the maximum servo travel. Also, the "Fine tune" function is which can
adjust the rate for left and right separately.
Type: EXP (Steering Exponential) and VTR can be selected, it defaults the EXP type.
If the curve type selects EXP, the steering operates will change with a curved curve from the
neutral point to the endpoint. While if the curve type selects VTR, the steering operates will
change with a linear curve from the neutral point to the high point.
EXP curve: It is used to adjust the sensitivity of the direction wheel both in a neutral position
and ends. Taking the center line of the EXP as the demarcation
point, if set the steering curve type as Quick EXP curve and the
EXP rate is 100%, the steering acceleration is completed in the
front 80% of the rudder amount range, thus achieving the effect
that the first half of the rudder amount changes faster than the
second half. The slow EXP curve is the opposite.
Quick/Slow: +100 indicates the quick EXP rate, and -100
indicates the slow EXP rate.
The vertical cursor line moves in conjunction with the
operation of the steering wheel.
EXP rate: the initial value of EXP rate is 0%, -100% to +100%
can be selected. With the change of this value, the sensitivity of left and right steering is adjusted
in the same ratio.
If you want to make the steering get the higher sensitivity or make steering more gentle,
click "+" to increase the value, or click "-" to decrease the value. When the value of EXP is not
0%, click Quick or Slow to switch the value quickly.
Fine tune(left): To set the right and left steering curves separately. The initial value is 0%,
-200% to +200% can be selected.
Fine tune(right)：To set the right and left steering curves separately. The initial value is 0%,
-200% to +200% can be selected. Click "-" can decrease the value, and click "+" can increase
the value.
VTR curve: If the curve type selects VTR, the steering operates will change with a linear
curve from the neutral point to the high point. Taking the center line of the VTR as the
demarcation point, if set the steering curve type as Quick VTR curve and the VTR rate is 100%,
the steering acceleration is completed in the front 80% of the rudder amount range, thus
47
RadioLink Electronic Limited
www.radiolink.com