RadioLink RC8X Instruction Manual page 31

Step: indicates the interval of the number change every time the button is pressed. For
example, set the Step value to 6, and then each time the DT1 button is pressed, the value will
increase or decrease by 6. The value of Step is defaults 2.
Function 1: DT1/DT2/DT3/DT4/DL1 can be set to control one of the functions as below:
Steering trim, throttle trim, rotary knob trim, flap, dual rate, sub trim channel1/2/3/4/5/6/7/8,
acceleration forward/brake1/ brake2/ brake3, steering curve, throttle curve, steering speed
turn/return, throttle speed turn(high/middle/low), throttle speed return(high/middle/low), ABS
(return brake1/2/3), ABS (delay brake1/2/3), ABS (cycle brake1/2/3), traction control (return
/delay/cycle), brake1/2/3 rate, brake EXP(brake1/2/3), brake delay(brake1/2/3), tilt mixing(RUD
to FLP), tilt mixing(FLP to RUD), idle up, programable mixing1/2/3/4/5/6/7/8 A/B, 4WS front rate,
4WS rear rate, dual ESC, dual ESC ratio, gyro gain, Ackermann, condition.
Function 2: The four DT buttons can also be used as four 3-position switches by setting. For
details of setting, please refer to chapter 1.2.8 Three Position Switch.
"NULL": indicate that the function is not enabled.
Note: After assigning functions to each trim in this menu, if the trim button is selected again
when setting other functions, the following prompt "Do you want to replace it?" will appear. If
you want the trim button to control the original function, please click "NO"; if you want the trim
button to control the new function, please click "YES".
The above picture
controls the steering
again when setting
"Do you want to
"YES", DT1 will control the Idle up and no longer control the steering trim; if you click "NO", DT1
will still control the steering trim, but not the Idle up function.
Trim/Dial sound select:
Click 1/2 at the top right corner to switch the setting menu. The sound of button
DT1/DT2/DT3/DT4/DL1 can be set in this menu.
DTxA: the sound set for pushing the button forward.
is taken as an example. DT1 initially
trim by default.
Idle up function, the above prompt
replace it?" will appear. If you click
30
RadioLink Electronic Limited
www.radiolink.com
If DT1 is selected