Configuring Gx Iec Developer To Access The Plc On Ethernet - Mitsubishi Electric FX Series Training Manual

Ethernet Communications
Configuring GX IEC Developer to access the PLC
18.3
on Ethernet
Please make the following settings in order to access the PLC via an Ethernet network and an
Ethernet interface module.
From the Online menu, select Transfer Setup and then Ports :
The default connection is for the PC Side I/F to use serial connection to the PLC CPU mod-
ule. Change the PC Side I/F to Ethernet board by clicking on it as shown above, and say-
ing Yes to the question about present setting will be lost (i.e. the setting of serial to CPU).
Training Manual GX IEC Developer

Configuring GX IEC Developer to access the PLC on Ethernet

18 - 7