Setting From Gx Developer - Mitsubishi Electric Melsec Q Series User Manual

7 Setting and procedure for operation

7.7 Setting from GX Developer

This section explains setting from GX Developer necessary to use QE81WH. Before performing this
setting, install GX Developer and connect the Management CPU with the PC using a USB cable. For
details, refer to the manual of CPU module.
7.7.1 I/O assignment setting
(1) Double-click the dialog box of "PLC Parameter" in the GX Developer Project.
(2) Click "I/O assignment".
(3) Set the following item to the slot*1 to which QE81WH has been attached.
Table 7.7.1-1 Setting items on the "I/O assignment" tab
Item
Type
Model name
Points
Start XY
*1 is a case where QE81WH is attached to the slot 0.
Figure 7.7.1-1 Dialog box of "I/O assignment"
Select "Intelli.".
Enter the model name of the module.
Select 16 points.
Enter the initial I/O number of QE81WH.
7 - 25
Descriptions
QE81WH