Omron SYSMAC CS Series Operation Manual page 128

CS1W-PMV01 Isolated-type Analog Output Unit
Item
Function Rate-of-change
limit
Output high/low
limits
Output hold
Isolation
Insulation resistance
Dielectric strength
External connections
Unit number settings
Indicators
Front panel connector
Alarm time for CPU Unit cycle
time
Current consumption
Dimensions
Weight
Standard accessories
This function can be used to control the speed of up and down changes in analog out-
put values.
This function can be used to place high and low limits on analog output values.
This function holds the analog output value to the previous value or to a specified pre-
set value when any of the following CPU Unit errors occurs, and outputs the analog
output value in the CIO Area when the error is cleared.
• CPU Unit fatal error (including FALS execution)
• CPU error in CPU Unit
• All outputs turned OFF with Output OFF Bit
Between outputs and between output terminals and PC signals: Isolation by trans-
former and photocoupler
20 MΩ (at 500 V DC) between outputs
Between outputs: 1,000 V AC, at 50/60 Hz, for 1 min, leakage current 10 mA max.
Terminal block (detachable)
Set by rotary switches on front panel, from 0 to 95.
Three LED indicators on front panel (for normal operation, errors detected at the Ana-
log Output Unit, and errors related to the CPU Unit).
Output connector terminal block (detachable)
0.3 ms
5 V DC at 150 mA max., 26 V DC at 160 mA max.
35 × 130 × 126 mm (W × H × D)
Note The height including the Backplane is 145 mm.
450 g max.
None
Note The following diagram shows the relationship between the allowable load
resistance and the current output.
Current output
22.4 mA (115%)
20 mA (100%)
0.8 mA (−20%)
Specifications
Allowable load resistance (Ω)
Section 2-9
115