Cabling A 14U Library Containing Fibre Drives; Cabling Of A 14U Library Containing Multiple Fibre Drives; Module Communication - IBM System Storage TS3310 Setup And Operator Manual

5. Install one end of the power cord (
6. Continue with "Step 5: Powering ON the Library" on page 3-22.

Cabling a 14U Library Containing Fibre Drives

To cable a 14U library (control module + 9U expansion module) with fibre drives,
complete the following steps:
3
2
Figure 3-17. Cabling of a 14U library containing multiple fibre drives
1. Install a module communication terminator in the upper receptacle of the
2. Install one end of the module-to-module communication cable (
receptacle in a power supply in your library, then connect the other end of the
cord to your power source. Repeat this for every power supply in your library.
4
1
Module communication
1
terminator
Module-to-module
2
communication cable
Ethernet cable (customer
3
supplied)

Module communication

4
terminator
upper module of your library (
Figure 3-17) in the lower receptacle of the upper module of your library, then
install the other end in the upper receptacle of the lower module of your
library.
5
in Figure 3-16 on page 3-18) in the
7
Power cord (upper module)
5
Power cord (lower module)
6
Fibre drive-to-network cables
7
4
in Figure 3-17).
Chapter 3. Installing the Library
5
6
2
in
3-19