Placing The Library In The Rack; Scsi Drive Sled (Detail) - IBM System Storage TS3310 Setup And Operator Manual

Removing a Drive Sled
Important: Make note of each drive position and associated drive serial number
Figure 3-9. SCSI Drive Sled (detail)
For each drive installed in the library:
1. Loosen the two thumb screws (
2. To remove the drive sled, grasp the handle (

Placing the Library in the Rack

v To place a 5U library (control module) in a rack:
v To place a 14U library (control module + 9U expansion module) in a rack:
3-12
TS3310 Tape Library Setup and Operator Guide
(S/N) in each unit of the library on the Appendix D, "Library
Configuration Form," on page D-1. This information will be important
when repopulating the library with the drive(s).
1
place by turning them counterclockwise.
toward you, while supporting the drive sled from underneath.
1. With a person on each side, lift the library and slide it onto the rail shelves
in the rack until the library is flush with the flange on the rear of each Rack
Mount Kit rail.
2. Install and tighten rear thumb screws located on the flange on the rear of
each Rack Mount Kit rail.
1. With a person on each side lifting the library using the sling and one person
holding the front of the library, slide it partially onto the rail shelves in the
rack.
2
4
2
in Figure 3-9) that hold the drive sled in
5
in Figure 3-9) and slowly pull it
5
3