IBM System Storage TS3310 Setup And Operator Manual page 69

2. Grasp the handle (
Figure 3-13. Tape Drive (detail)
3. Tighten the two thumb screws (
4. Reconnect the drive sled cable.
5. Repeat this procedure for all drives to be re-installed in the library.
6. Record drive location and other information on the Appendix D, "Library
Replacing a Power Supply
5
drive slot, while supporting the drive sled from underneath.
1
place by turning them clockwise.
a. For a SCSI drive sled, plug the cable and terminator into the drive sled.
Tighten the thumb screws that hold the SCSI cable (
the SCSI receptacle) and terminator (
them clockwise.
b. For a Fibre Channel drive sled, connect the fibre cable.
Configuration Form," on page D-1.
in Figure 3-13) and slowly slide the drive sled into the
2
2
in Figure 3-13) that hold the drive sled in
3
in Figure 3-13) in place by turning
5
3
4
4
in Figure 3-13 shows
Chapter 3. Installing the Library
3-15