Configuring The Library For Remote Access; Taking A Logical Library Offline/Online; Shutting Down/Restarting The Library - IBM System Storage TS3310 Setup And Operator Manual

The authentication algorithm is set to MD5 and the encryption is disabled
system-wide.
Selecting Apply applies the modified settings to all three tabs: SSL, Trap
Registration, and SNMP Version.

Configuring the Library for Remote Access

You must configure your library's network before you can use the remote Web
User Interface. For more information, see "Modifying Network Settings" on page
4-6 and "Step 4: Set up the Library Network Configuration" on page 6-3.

Taking a Logical Library Offline/Online

From the Operator Panel: Operations → Logical Library Mode
From the Web User Interface: Manage Library → Logical Libraries
It is sometimes necessary to take a logical library offline before adding or replacing
certain parts in the library. After those parts are added or replaced, it is necessary
to bring the logical library back online. These menu items allow you to take logical
libraries offline and online.

Shutting Down/Restarting the Library

From the Operator Panel: Operations → Shut down/Restart
When powering down the library under normal circumstances (e.g. the library is in
an idle state - no movement, backup operations, accessing of log files, etc), it is
acceptable to power down the library via the power switch. However, when there
is an operation in process, the library needs to be shutdown using this menu item.
Shutdown shuts down the library's operating system and firmware. This prepares
the library to physically turn off power. When performing a shutdown, the library
finishes all active commands received from the host application and does not
process any new commands. It also shuts down all logical libraries. Always
perform a shutdown from the Operator Panel before removing power from the
library.
To completely remove power from the library, including the power supplies, press
the front power switch once. To turn the library back on, press the front power
switch again and then follow the login procedure.
From the Operator Panel: Setup → Network Config
Chapter 7. Operating Procedures
7-7