Removing The C-Clip From The Leader Pin - IBM System Storage TS3310 Setup And Operator Manual

Figure 8-13. Winding the tape out of the cartridge. Turn the cartridge manual rewind tool clockwise to see the end of
the tape, then turn it counterclockwise to bring the tape to the cartridge door.
2
Figure 8-14. Removing the C-clip from the leader pin. Use your fingers to push the C-clip from the leader pin.
10. Fold the tape over the leader pin and hold it with your fingers (see
5. On the leader pin (
in Figure 8-14). The C-clip is a small black part that secures the tape (
Figure 8-14) to the pin.
6. Remove the C-clip from the leader pin by using your fingers to push the clip
away from the pin. Set the pin aside and discard the clip.
3
1
7. Position the tape in the alignment groove of the leader pin attach tool (
Figure 8-15 on page 8-16).
8. Place a new C-clip into the retention groove (
on the leader pin attachment tool and make sure that the clip's open side
faces up.
9. Place the leader pin into the cavity (
leader pin attach tool.
Note: To prevent the leader pin from rolling into the cartridge, in the
following step use care when folding the tape over the pin.
Figure 8-15 on page 8-16).
1
in Figure 8-14), locate the open side of the C-clip (
3
in Figure 8-15 on page 8-16) of the
2
in Figure 8-15 on page 8-16)
Chapter 8. Using Ultrium Media
2
3
in
1
in
8-15