Cabling A 5U Library Containing Scsi Drives; Cabling Of A 5U Library With Fibre Drives - IBM System Storage TS3310 Setup And Operator Manual

2
Figure 3-15. Cabling of a 5U library with fibre drives
1. Install the upper module communication terminator (
2. Install the lower module communication terminator (
3. Install one end of the customer-supplied Ethernet cable (
4. Install one end of the drive fibre cable (
5. Install one end of the power cord (
6. Continue with "Step 5: Powering ON the Library" on page 3-22.

Cabling a 5U Library Containing SCSI Drives

To cable a 5U library (control module) with SCSI drives, complete the following
steps:
3
1
Module communication
1
terminator
Ethernet cable (customer
2
supplied)
Module communication
3
terminator
the Library Control Blade Ethernet port, then connect the other end of the cable
to your network.
library, then connect the other end of the cable to your network. Repeat this for
every fibre drive in your library.
power supply in your library, then connect the other end of the cord to your
power source. Repeat this for every power supply in your library.
5
Power cord
4
Fibre drive cable
5
1
5
in Figure 3-15) in a fibre drive in the
4
in Figure 3-15) in the receptacle in a
Chapter 3. Installing the Library
4
3
in Figure 3-15).
in Figure 3-15).
2
in Figure 3-15) in
3-17