T073: I/O Storage Door Open; T074: Sled Auto-Leveling Failure; T075: Unsupported Module Configuration - IBM System Storage TS3310 Setup And Operator Manual

T073: I/O Storage Door Open

Description
Detection Scenario
Root Causes
Possible FRU Replacements
Resolution

T074: Sled Auto-Leveling Failure

Description
Root Causes
Possible CRU Replacements
Possible FRU Replacements
Resolution

T075: Unsupported Module Configuration

Put your short description here; used for first paragraph and abstract.
10-28
TS3310 Tape Library Setup and Operator Guide
Certain IO doors can be designated as storage slots.
When one of these doors is open, the system should not
become operational because these storage slots would
not be available to the robot. The ticket is posted as a
means of informing the user that the library cannot
become operational and that they should close the door
so the system can lock it and start using it.
1. When the main doors are closed and the robot
attempts to initialize, the state of "I/O Storage
Doors" will be checked.
2. When the library powers up and the robot attempts
to initialize, the state of the "I/O Storage Doors" will
be checked.
1. I/O Storage door is left open by user.
2. Hardware failure in the I/O door open/closed
sensing.
v I/O Lock Assembly
v I/O mechanism
Perform "DR034: IO Storage Door Open Resolution" on
page 10-39.
The normal auto level process for a sled did not work.
When a drive sled is inserted into a booted up library or
when a library powers up, the firmware level of the
drive sleds is checked to be consistent with the level
required by the main library firmware. If the level is not
correct, the sled will be up-leveled or down-leveled
accordingly. Failure in this process to set the correct
firmware level in the sled results in this ticket.
1. Physical interruption of the code down load process.
2. Code bugs.
3. Hardware failures that result in intermittent or failed
communication between library and drive sled.
v Firmware
v Drive sled
Chassis
Perform "DR033: Drive Sled Auto Level Resolution" on
page 10-38.