Omron CS Series Operator's Manual page 239

I/O Memory Allocation
Address
Words Bits
A500 A50014
A50015
A501 A50100
to
A50115
A502 to A50200
A507 to
A50715
A508 A50809
A50811
224
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Name
Error Log Turn this bit ON to reset the Error
Reset Bit Log Pointer (A300) to 00.
The contents of the Error Log
Area itself (A100 to A199) are not
cleared. These words can be
cleared from a Programming
Device or by writing 0000 to all of
the words.
(This bit is automatically reset to
0 after the Error Log Pointer is
reset.)
Output OFF Turn this bit ON to turn OFF all
Bit outputs from Basic I/O Units and
Special I/O Units.
CS/CJ- Turn these bits ON to restart
series CPU (initialize) the CS/CJ-series CPU
Bus Unit Bus Unit with the corresponding
Restart Bits unit number. Bits 00 to 15 corre-
spond to unit numbers 0 to F.
When a restart bit is turned ON,
the corresponding CS/CJ-series
CPU Bus Unit Initializing Flag
(A30200 to A30215) will be
turned ON. Both the restart bit
and initializing flag will be turned
OFF automatically when initiali-
zation is completed.
Special I/O Turn these bits ON to restart
Unit Restart (initialize) the Special I/O Unit
Bits with the corresponding unit num-
ber.
Differenti- ON when the differentiate moni-
ate Monitor tor condition has been estab-
Completed lished during execution of differ-
Flag entiation monitoring.
(This flag will be cleared to 0
when differentiation monitoring
starts.)
Trace Trig- ON when a trigger condition is
ger Monitor established by the Trace Start Bit
Flag (A50814). OFF when the next
Data Trace is started by the
Sampling Start Bit (A50815).
CS/CJ-series PLC
Function
0à1: Clear Same as
0 to 1: Re-
start
1 to 0: Re-
start com-
pleted
Turned
OFF by the
system
when the
Unit has
been re-
started.
0 to 1: Re-
start
1 to 0: Re-
start com-
pleted
Turned
OFF by the
system
when the
Unit has
been re-
started.
1: Monitor
condition
established
0: Not yet
established
1: Trigger
condition
established
0: Not yet
established
or not trac-
ing
Section 9-3
CX-Simulator
Settings Function
CS/CJ-series
PLC.
Not used.
Not used.
Not used.
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.
Settings
Not reset
in the
Program
mode.