Omron CS Series Operator's Manual page 230

I/O Memory Allocation
Address
Words Bits
A402 A40202
A40203
A40204
A40205
A40206
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Name
Special I/O ON when an installed Special I/O
Unit Setting Unit does not match the Special
Error Flag
I/O Unit registered in the I/O ta-
(Non-fatal ble. The CPU Unit will continue
error) operating and the ERR/ALM indi-
cator on the front of the CPU Unit
will flash.
The unit number of the Unit
where the setting error occurred
is indicated in A428 to A433.
(This flag will be turned OFF
when the error is cleared.)
CS/CJ- ON when an installed CS/CJ-
series CPU series CPU Bus Unit does not
Bus Unit match the CS/CJ-series CPU
Setting Bus Unit registered in the I/O
Error Flag table. The CPU Unit will continue
(Non-fatal operating and the ERR/ALM indi-
error) cator on the front of the CPU Unit
will flash.
The unit number of the Unit
where the setting error occurred
is written to A427.
(This flag will be turned OFF
when the error is cleared.)
Battery ON if the CPU Unit's battery is
Error Flag disconnected or its voltage is low
(Non-fatal and the Detect Battery Error set-
error) ting has been set in the PLC
Setup.
SYSMAC ON when an error occurs in a
BUS Error data transfer in the SYSMAC
Flag BUS system. The number of the
(Non-fatal Master involved is indicated with
error) bits A40500 and A40501.
Special I/O ON when an error occurs in a
Unit Error data exchange between the CPU
Flag Unit and a Special I/O Unit (in-
(Non-fatal cluding an error in the Special I/O
error) Unit itself).
CS/CJ-series PLC
Function
1: Setting
error de-
tected
0: No set-
ting error
1: Setting
error de-
tected
0: No set-
ting error
1: Error
0: No error
1: Error
0: No error
1: Error in
one or
more Units
0: No errors
in any Unit
Section 9-3
CX-Simulator
Settings Function
Not used.
Not used.
Not used.
Not used.
Not used.
Settings
215