Autel AUTOLINK AL529 Manual page 58

Ready Test Application
The purpose of this function is to indicate which of the vehicle's monitors
have run and completed their diagnosis and testing, and which ones have
not yet run and completed testing and diagnosis of their designated sections
of the vehicle's emission system. All data shows on one screen, which
provides a simple profile of vehicle at a glance, saving diagnosis time and
improving technician productivity.

Use the UP/DOWN scroll button and LEFT/RIGHT scroll button to
select Ready Test from Main Screen, and press the OK button.
As post-repair diagnostic tool
This function can be used (after the vehicle has done any emission-related
repairs) to confirm that the repair has been performed successfully.
After repairs, some drive cycles are required to reset the monitoring systems.
Drive cycles vary among vehicles and for each monitor in any particular
vehicle.
Use the following procedure to check if the repair has been done correctly:
1) Connect the scan tool to the vehicle's DLC and erase the DTC(s) from
the vehicle's computer memory.
2) After the erase procedure is performed, status of most monitors will be
changed. Leave the scan tool connected to the vehicle, and select
Ready Test from Main Screen.
3) Keep on driving the car till the scan tool notifies you safely with color
LEDs and audible tone that the drive cycle has been completed and the
Figure 5-1 Sample Ready Test Screen
54