Autel AUTOLINK AL529 Manual page 15

Figure 2-7 Sample Unit of Measure Screen
3) Press the OK button to save your selection and return to previous menu.
Key Beep Set
This function allows you to turn on/off the build-in speaker for key pressing.

The default setting is Beep On.
1) From System Setup screen, use the UP/DOWN scroll button to select
Key Beep Set and press the OK button.
2) From Key Beep Set menu, use the UP/DOWN scroll button to select
Beep ON or Beep OFF to turn on/off the beep.
Figure 2-8 Sample Key Beep Set Screen
3) Press the OK button to save your selection and return to previous menu.
Status Beep Set

The default setting is Beep On.
This function allows you to turn on/off the build-in speaker for the LEDs in
diagnostic testing. Different audio tone corresponds to different LED lamp.
This function is invaluable when performing diagnostics alone, or working in
bright areas where LED illumination alone is not sufficient.
11