NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Use your fingertips and lift the flap to access the memory-module slot.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Slide the memory module firmly into the memory-module slot at an angle and press it down until it clicks into place.
NOTE:
If you do not hear the click, remove the memory module and reinstall it.
4. Close the flap.
Figure 16. Replacing the memory module
1. tab
3. memory module
Post-requisites
1. Replace the
heat
sink.
Replacing the memory module
computer. After working inside your computer, follow the instructions in
2. notch
4. flap
www.dell.com/
Replacing the memory module
12
After
27