NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
Follow the procedure from step 1 to step 6 in
Procedure
1. Disconnect the battery cable from the system board.
2. Remove the three screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
Figure 9. Disconnecting the battery
1. battery cable
3. battery
3. Tilt the battery (applicable for configuration with hard drive only) to release the tab on the battery from the hard-drive
bracket.
4. Lift the battery off the palm-rest and keyboard assembly.
16
Removing the battery
Removing the battery
computer. After working inside your computer, follow the instructions in
"Removing the base
cover".
2. M2x3 screws (3)
4. palm-rest and keyboard assembly
5
After
www.dell.com/