Chapter 24: Replacing The Display Assembly; Procedure; Post-Requisites - Dell Inspiron 11 3000 Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•

Procedure

•

Post-requisites

Procedure
CAUTION: Place the computer on a soft and clean surface to avoid scratching the display back-cover and
antenna assembly.
1. Place the display assembly on a flat and clean surface.
2. Align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2.5x6) that secure the display assembly to the palm-rest and keyboard assembly.
4. Slide the display cable into the connector on the system board and close the latch to secure the cable.
5. Slide the display-cable bracket into the slot on the palm-rest and keyboard assembly.
6. Align the screw hole on the display-cable bracket with the screw hole on the system board.
7. Replace the screw (M2x3) that secures the display-cable bracket to the system board.
Post-requisites
1. Replace the wireless card.
2. Follow the step 4 procedure in
3. Replace the battery.
4. Follow the procedure from step 2 to step 5 in
Replacing the display assembly
computer. After working inside your computer, follow the instructions in
"Replacing the I/O board".
"Replacing the base cover".
Replacing the display assembly
24
After
www.dell.com/
47