Changing The Max And Off; Zone Labels: Naming A Scene Or Zone - µ-Dimension D4006 User Manual

Changing the MAX and OFF Lighting
Levels
Reducing the maximum output voltage to the lamps by 5% can
extend lamp life significantly. This can be valuable when
incandescent lights are located where it is difficult to replace
them.
To change the MAX lighting level:
Step 1:
The lighting levels fade to the current maximum level.
•
Step 2:
Step 3:

Zone Labels: Naming a Scene or Zone

You can program alphanumeric labels with up to 14 characters
for any Scene MAX, OFF or Zone ID buttons.
To name a Scene or a Zone:
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Page 55
Press the MAX button.
Using the Zone Up
the LCD display to adjust each zone to the maximum
value that you need.
Press and hold the MAX (or OFF) button to record
the scene and set fade times just like you would
scenes 1-16.
When the Double Bump feature is on, tapping the
MAX or OFF buttons twice overrides any high and low
limits. Therefore, if MAX and OFF are set at any
levels other than full bright and full off, the Double
Bump feature should be turned off.
Press the Menu/Cancel button.
Press the Up
LABELS? flashes on the LCD display.
Press the Select/Save button.
Press the SCENE, MAX, OFF, Zone ID or Up
Down button you want to edit.
Press the Left
character to edit,
or proceed to the next step if you want to change the
current character.
or Down
and Down
and Right
buttons beneath
buttons until EDIT
or
buttons to select a