Table of Contents
Advertisement
From the advanced menus (see page 19), find the
Step 1:
menu which reads:
Use Up
Step 2:
you wish to edit
Use Up
Step 3:
press SELECT to save.
Repeat until all settings have been adjusted as
Step 4:
appropriate.
The settings which can be adjusted from this menu are as
follows:
Readback Request
In the event that multiple control devices are controlling the
same dimmer or relay, it's possible that the actual state of the
circuit will differ from that of this master station. In this case, it's
helpful for this device to periodically check the state of each
circuit. This is called "readback" because the level is read back
from the circuit. This setting determines whether or not this
readback action is periodically performed.
• Yes - dimmer levels will periodically be requested
• No - dimmer levels will never be requested.
Bump Mode
There is a special feature for the MAX and OFF buttons which
upon a double bump (quick double press) instead of going to
their user recorded setting, will take all levels instantly to 100%
for MAX or all levels instantly to 0% for off. This feature can be
controlled from the BUMP MODE option under the misc. settings
menu. Valid settings are as follows:
Leviton Dimensions 4000 Series Architectural Lighting Controller
MENU
MISC SETTINGS
then press SELECT.
or Down
to select then menu option
MISC SETTINGS
LOCK: ENABLED
then to edit, press SELECT.
or Down
Configuration Guide
to edit the values, then
Page 36
Advertisement
Table of Contents
