Table of Contents
Advertisement
To set the starting channel number on a device with only
dimmers:
The display should be steady indicating the starting
Step 1:
channel number. If it is flashing, push and hold the up
button for approximately 3 seconds. The display then
will be steady.
Use the Up/Down arrows until the desired starting
Step 2:
channel number is shown.
Push and hold the Down/Set button for approximately
Step 3:
three seconds until the number start rapidly flashing.
This indicates that the new value is being saved.
"Configuration of Dimmers at another panel" on
page 31
Leviton Dimensions 4000 Series Architectural Lighting Controller
There are many other configuration parameters for
a remote dimmer. These should be set from a
D4206 or D4200 master station. Reference
Configuration Guide
Page 34
Advertisement
Table of Contents
