Table of Contents
Advertisement
Devices with dimmers only (D4006)
Setting up units with only dimmers requires a few basic steps
which when followed will ensure success of your lighting control
system:
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Step 8:
Step 9:
• Depending upon the desired specific behavior of this
device, configuration may be complete or additional
modifications may be necessary. Regardless, a full perusal
of this manual is required to understand all device
configuration options.
Page 13
Confirm all connections have been completed and load
circuits are without fault.
Confirm network is terminated correctly, reference
installation guide for additional information.
Complete all "System Layout Charts" on page 68 to
confirm a clear understanding of all system and
configuration requirements.
Set the network ID, see page 33.
Set the starting channel number, see page 33.
For any load types which are not incandescent, adjust
dimmer load types as appropriate. See "Configuration
of Dimmers at another panel" on page 31
Configure ID's and channel patches at all other
network devices.
From the controlling device, activate the lighting levels
in this dimmer. If controlling from a D4200 or D4206,
simply pushing the MAX button will do.
Celebrate!!! You're all done.
Advertisement
Table of Contents
