Devices With Dimmers Only (D4006) - µ-Dimension D4006 User Manual

Devices with Dimmers Only (D4006)

Configuration of a device with dimmers is a two part process: Part
1 is configuration at the device, and part 2 is the configuration of
the dimmer parameters from a D4200 OR D4206 master station
using the "Remote Panels" menu option.
At the remote dimmer there are only two things which can be
configured:
• Network ID (see page 20.)
• Starting network Channel Number (see page 24.)
For more information about the implication of the two settings,
please reference the indicated sections and page numbers.
To set the network ID on a device with only dimmers:
Step 1:
Step 2:
Step 3:
Page 33
D4006 - Front Panel
The display should be flashing approximately once per
second indicating that the network id is showing. If
not, push and hold the up button for approximately 3
seconds. The display then should be flashing.
Use the Up/Down arrows until the desired network ID
is shown.
Push and hold the Down/Set button for approximately
three seconds until the number start rapidly flashing.
This indicates that the new value is being saved.