Dimmer To Circuit Patch - µ-Dimension D4006 User Manual

Dimmer to Circuit Patch

Your device, depending on the model, may have a number of
dimmers. These dimmers must be assigned (patched) to a
network channel. Just like zones, a dimmer may belong to only 1
network channel. However, a dimmer may belong to up to (4)
groups. Unlike zones, there is no separate menu structure for the
dimmer/circuit patch. It is handled as part of dimmer
configuration. For additional information on the implementation
of a dimmer/circuit patch, please see "Configuring Dimmers" on
page 28.
Notes on Patching
• The default patch for zones, is a consecutive patch starting
at zone 1, channel 1.
• The default patch for dimmers, is a consecutive patch
starting at dimmer 1, network channel 1.
• Zones and dimmers need not be patch consecutively
• If you're using the D4206 or D4006, the dimmers will
respond to any network command from any network device
for that channel.
• If you're using a D4200 or D4206, the zones can be
patched to any network channel, 1-2048, and can control
any circuit "listening" to that channel.
• If you're using a D410x, the dimmers will only respond to
commands issued from the controller containing the
dimmers and they do not have any patch settings.
Page 27
It is helpful to complete the dimmer patching
chart on page 70.