ITech IT8000 Series Programming Manual page 198

Error Error Message
Code
224 Front panel timeout
225 Front Crc Check error
226 Front Cmd Error
401 CAL switch prevents
calibration
402 CAL password is incorrect
403 CAL not enabled
404 Computed readback cal con-
stants are incorrect
405 Computed programming cal
constants are incorrect
406 Incorrect sequence of calibra-
tion commands
407 CV or CC status is incorrect for
this command
408 Output mode switch must be in
NORMAL position
600 Lists inconsistent [lists have
different list lengths]
601 Too many sweep points
602 Command only applies to
RS232 interface
603 FETCH of data that was not
acquired
Copyright © Itech Electronic Co., Ltd.
Error Messages
Description
The serial port connection be-
tween the front panel and the
control board has timed out.
The CRC check of the serial
port between the front panel
and the control board is
incorrect.
The serial port command be-
tween the front panel and the
control board is incorrectly
used.
Calibration is disabled due to
the status setting of the calibra-
tion switch.
The calibration password is
incorrect.
Calibration is not enabled.
An error occurred in reading
the calibration data.
An error occurred in calculating
the calibration data.
The execution order of the cali-
bration commands is incorrect.
The CC or CV status of this
command is incorrect.
The switch for the output mode
must be NORMAL.
The lists are inconsistent, such
as a different list length.
There are too many sweep
points.
This command only applies to
the RS232 interface.
The data related to the FETCH
command is not acquired.
185