ITech IT8000 Series Programming Manual page 195

Error Error Message
Code
-168 Block data not allowed
-170 Expression error
-171 Invalid expression
-178 Expression data not allowed
command execution related errors
-200 Execution error [generic]
-221 Settings conflict [check current
device state]
-222 Data out of range [e.g., too
large for this device]
-223 Too much data [out of memory;
block, string, or expression too
long]
-224 Illegal parameter value [de-
vice-specific]
-225 Out of memory
-230 Data Corrupt or Stale
-270 Macro error
-272 Macro execution error
-273 Illegal macro label
Copyright © Itech Electronic Co., Ltd.
Error Messages
Description
The data type is not allowed to
be block data.
The expression is incorrect.
Invalid expression.
Expression data is not allowed.
If the status or setting of the
command is incorrect, the error
will be reported. For example,
*TRG must be executed when
the LIST trigger source is set to
BUS, so executing *TRG will
prompt the error when the LIST
trigger source is set to Manual.
A data element could not be
executed because of the
present instrument state.
A data element could not be
executed because the value
was outside the valid range.
A data element was received
that contains more data than
the instrument can handle.
An exact value was expected
but not received.
The device has insufficient
memory to perform the re-
quested operation.
Possible invalid data. A new
reading was started but not
completed.
Macro definition error.
Macro execution error
Illegal macro tag
182