Software Overview - Xylem Ai1 Product Manual

4. Software Overview

The free application "Device Configuration Utility" (DevConfig) is used for configuring the station and is available for
download from here: http://measci.com/devconfig.exe
Refer to DevConfig help for connection instructions, following the steps shown below to establish a connection.
1. The Ai1 is compatible with the
CR300 series. Select this datalogger.
3. When plugging in a USB cable use
the Direct type. If connecting using
Pakbus Router (PBRouter) or through
Eagle.io, use the IP type.
5. Use the connect button to connect.
You will most likely need to install USB drivers on the first connection to the station. See Step 2 in the image above
for more instructions. Once the connect button is clicked, DevConfig will search for a connected logger and load the
configuration information, as per the sequence below.
The main tab to use is Data Monitor which shows both the real-time and logged measurements. The table list
depends on the program which is supplied to suit the sensors ordered. The tables always include Ai1 (logged status
and diagnostic information), DataTableInfo (how much data is stored in each table), ErrorLog (stored messages
recording program errors and when they occurred, for fault analysis), Public (real-time information and program
control) and the Status table (real-time status and diagnostic information). Public is the most common starting
Page | 29
2. On first use, you may need to install a USB driver. Click
this button and follow these steps.
4. Once the USB driver is installed, use the pull-down option to find the right
COM port, it will appear as the CR300 datalogger type