Xylem Ai1 Product Manual page 20

PCSONTEK
PCJST
BHK
Bulkhead Kit
For extension cables, the connector gender is as described in the schematic here:
It is possible to order an additional M12 sensor connector for adding a second sensor. A second port for an M12
connector is available on the side of the Ai1, fitted with a bung to keep the port sealed. The sensor connector is
supplied as a kit including the panel mounted connector, molded cable, and field wireable connector.
Internal screw terminals for changing from
the default wiring to suit custom sensors.
Weather-proof plug installed in
pre-drilled location for an
nd
optional 2 M12 sensor port.
Port label showing internal wiring.
Figure 9 – Default Port 1 M12 sensor connector and internal wiring
Page | 20
Cable set to connect the sensor cable to the Sontek IQ serial
adapter, with 12V USB power supply to power the sensor and
adapter from the PC during configuration.
Cable connector to configure peripherals inside the Ai1 such as
the EXO Signal Output Adapter (SOA), where used
Bulkhead kit includes prewired bulkhead connector and SEN1
sensor cable kit. This can be delivered with a SEN2 sensor cable
if confirmed at time of order. The bulkhead connector is easily
added to the Ai1 to allow an additional sensor port. This can be
fitted in the factory if ordered with the Ai1 order or can be
fitted in the field using a predrilled port on the side of the Ai1.
Panel mounted M12 sensor connection
port, 5-pin, female. Allows easy sensor
connection with a weather-proof
connector.
Cable tie point