Appendix L (Field Firmware Upgrade) - RJS Inspector 5000 Operator's Manual

Appendix L

Appendix L (Field Firmware Upgrade)

1. Power Off the Inspector 5000
2. Connect an Ethernet cable (not included) to your
office network and the Inspector 5000
3. Turn On the Inspector 5000
4. After startup, press the Power button
5. Press the Right Arrow button twice to scroll to the
System Status page which has the first line of "IP
ADDR". The number most likely starts with
192.168.... (this depends on how your DHCP
router is configured). Write down this number.
Note:
Occasionally it takes a minute for the IP
address to refresh, exiting the Status screen
(by pressing Power) and the re-entering the
Status screen may be necessary
6. Go to your computer and open a web browser and
in the address bar enter the IP address written
down in Step 5.
7. The Inspector 5000 web server will load the
following page:
8. Click the Continue button
9. When prompted for a user name and password, use
password
RJS, Minneapolis, MN
104
Operator's Guide
003-4500