Mercedes-Benz GLE Owner's Manual page 497

494 Breakdown assistance
Observe the maximum permissible speed for
#
a tyre sealed with tyre sealant 80 km/h.
Affix the upper section of the TIREFIT sticker
#
to the instrument cluster in a location where
it will be easily seen by the driver.
* NOTE Staining from leaking tyre sealant
After use, excess tyre sealant may leak out
from the filling hose.
Therefore, place the filling hose in the
#
plastic bag that contained the TIREFIT
kit.
+ ENVIRONMENTAL NOTE Environmental
pollution caused by environmentally irre‐
sponsible disposal
Tyre sealant contains pollutants.
Have the tyre sealant bottle disposed of
#
professionally, e.g. at a Mercedes-Benz
Service Centre.
Stow the tyre sealant bottle, the tyre inflation
#
compressor and the warning triangle.
Pull away immediately.
#
Stop driving after approximately ten minutes
#
and check the tyre pressure using the tyre
inflation compressor.
The tyre pressure must now be at least
130 kPa (1.3 bar/19 psi).
& WARNING Risk of accident due to the
specified tyre pressure not being ach‐
ieved
If the specified tyre pressure is not achieved
after a brief drive, the tyre is too badly dam‐
aged. The tyre sealant cannot repair the tyre
in this instance.
Damaged tyres and a tyre pressure that is
too low can significantly impair braking and
handling characteristics.
Do not drive on.
#
Consult a qualified specialist workshop.
#
Countries that have Mercedes-Benz
Service24h: you will find a sticker with the tele‐
phone number, e.g. on the B‑pillar on the driver's
side.
Correct the tyre pressure if it is still at least
#
130 kPa (1.3 bar/19 psi). See the tyre pres‐
sure table on the fuel filler flap for values.
To increase the tyre pressure: switch on
#
the tyre inflation compressor.
To reduce the tyre pressure: press pres‐
#
sure release button 1 next to manometer
2.
When the tyre pressure is correct, unscrew
#
the filling hose from the valve of the sealed
tyre.
Screw the valve cap onto the valve of the
#
sealed tyre.