Table of Contents
Advertisement
6.4
MONITOR DISASSEMBLY
1.
Set the NPB-195 upside down, as shown in Figure 6-2.
Figure 6-2: NPB-195 Corner Screws
2.
Remove the four corner screws.
Caution: Observe ESD (electrostatic discharge) precautions when
disassembling and reassembling the NPB-195 and when handling any of the
components of the NPB-195.
3.
Separate the top case from the bottom case of the monitor, being careful not
to stress the wire harnesses between the cases. Place the two halves of the
monitor on the table as shown in Figure 6-3.
4.
Disconnect the Power Supply from J6 on the UIF PCB.
Section 6: Disassembly Guide
Corner screws
6-3
Advertisement
Table of Contents
Troubleshooting
