Table of Contents
Advertisement
6.9
COOLING FAN REMOVAL/INSTALLATION
8.
Install the seven screws in the Power Supply and tighten.
9.
Connect the fan harness to J1 on the Power Supply.
10. Complete steps 4 through 6 in paragraph 6.7.
11. Complete procedure in paragraph 6.5.
Removal
1.
Complete the procedures in paragraphs 6.2 and 6.4.
2.
Disconnect the fan wire harness from J1 on the Power Supply PCB (see
Figure 6-5).
3.
Lift the cooling fan from the slots in the bottom case (see Figure 6-8).
J1
Installation
4.
Insert the cooling fan into the slots in the bottom case with the padded sides
on the top and bottom and the fan's harness to the handle side of the case.
5.
Connect the cooling fan wire harness to J1 on the Power Supply PCB.
6.
Complete procedure 6-5.
Section 6: Disassembly Guide
Figure 6-8: Cooling Fan
6-9
Advertisement
Table of Contents
Troubleshooting
