6.12 ALARM SPEAKER REMOVAL/INSTALLATION
Removal
1.
Complete the procedures in paragraphs 6.2 and 6.4.
2.
Disconnect the speaker wire harness from J13 on the UIF PCB
(see Figure 6-11).
3.
Pull the retaining tab back from the speaker and lift the speaker out of the
top case.
Connect speaker
wires to J13 connector
Installation
4.
Pull the retaining tab back and insert the speaker into the top case.
5.
Connect speaker wire harness to J13 on the UIF PCB.
6.
Complete the procedure in paragraph 6.5.
Figure 6-11: Alarm Speaker
Section 6: Disassembly Guide
6-13