Mallinckrodt NELLCOR NPB-195 Service Manual page 14

Section 3: Performance Verification
3.3.1 Battery Charge
3.3.2 Power-up Performance
3.3.2.1 Power-On Self-Test
3-2
Perform the following procedure to fully charge the battery.
1. Connect the monitor to an AC power source.
2. Verify that the monitor is off and that the AC Power/Battery Charging
indicator is lit.
3. Charge the battery for at least 14 hours in standby.
The power-up performance tests (3.3.3.1 through 3.3.3.3) verify the following
monitor functions:
• 3.3.2.1 Power-On Self-Test
• 3.3.2.2 Power-On Defaults and Alarm Limit Ranges
Power On/Standby
1. Connect the monitor to an AC power source and verify that the AC
Power/Battery Charging indicator is lit.
2. Do not connect any input cables to the monitor.
LIMITS TREND SETUP
Soft keys
Figure 3-1: NPB-195 Controls
Alarm silence
NPB-195
%SP02
100
BPM
110
LIGHT
Contrast Adjust Adjust
Down Up