Hip Flip; Ring Scanner Strap; Figure 1-2 Hx2 Hip Flip, Audio - LXE HX2 Reference Manual

Getting Started

Hip Flip

The hip flip may be pre-assembled by LXE.
The wearable computer is ready for use. See Getting Started and Connecting the Battery and Ring
Scanner for more detailed instruction.

Ring Scanner Strap

The ring scanner finger loop is located under the ring scanner.
Pull gently on the end of the finger loop strap to separate the hook and loop fabric.
Slide your finger into the opened loop under the ring scanner.
Grasp the end of the finger loop strap and loosen, then tighten, the finger strap until the ring
scanner is comfortably snug and the scan aperture is secured in the desired location.
The ring scanner has a built-in quick disconnect designed for occasional safety hazards. It is not
intended for frequent, normal removal of the ring scanner from the hand.
Note:
E-EQ-HX2RG-D

Figure 1-2 HX2 Hip Flip, Audio

Do not touch, push against or brace your finger on the scan aperture at any time.
•
Unpack the Hip Flip. Slide the belt through the
loops on the Hip Flip. Do not put the hip flip
on yet.
•
Slide the battery into the battery sleeve on the
hip flip.
•
Snap all tethered devices to the connectors at
the back of the HX2. See Connecting the
Battery and Ring Scanner and Connecting the
Audio Cable and a Headset.
•
Snap the HX2 into the hip flip mounting
brackets. See Mounting Bracket Clips.
•
Attach the battery cable to the battery.
•
Put the hip flip on.
•
Slip the ring scanner (if included) over one of
your fingers, making sure your thumb or
trigger finger can easily reach the scan button.
See Ring Scanner Strap.
• Adjust the HX2 hip assembly for comfort.
Occasionally check all connectors for stability.
9
HX2 Reference Guide