18
Mounting Bracket Clips
Mounting brackets are pre-installed to the back of the HX3. The brackets (one on each side)
secure the HX3 to the mounting bracket clips on a hip flip.
The HX3 mount assembly is pre-installed to a hip flip.
Connect
Center the HX3 over the mount assembly and gently push down until both bracket clips (indicated
by the arrows shown above) snap over the brackets on the HX3. Carefully test the connection to
make sure the HX3 is secured to the hip flip.
Reset the connection by pressing down on either mounting clip to release the HX3 and try again.
Disconnect
Remove the HX3 from the mount assembly by pushing down on either mounting clip, or both,
until the HX3 mounting bracket disconnects.
Or you can disconnect one side, then lift the HX3 up at a 45 degree angle until the other side
disconnects. Lift the HX3 up and away from the mount assembly.
HX3 User's Guide
Figure 17 Mounting Brackets
Figure 18 Hip Flip Mount Assembly and Clips
Mounting Bracket Clips
E-EQ-HX3OGWW-C