Mounting Bracket Clips; Figure 1-15 Mounting Brackets; Figure 1-16 Armband And Hip Flip Mount Assembly And Clips - LXE HX2 Reference Manual

Components

Mounting Bracket Clips

Mounting brackets are pre-installed to the back of the HX2. The brackets (one on each side)
secure the HX2 to the mounting bracket clips on a hip flip or the armband.
The HX2 mount assembly is pre-installed to a hip flip or armband.
Connect
Center the HX2 over the mount assembly and gently push down until both bracket clips (indicated
by the arrows shown above) snap over the brackets on the HX2. Carefully test the connection to
make sure the HX2 is secured to the armband or hip flip.
Reset the connection by pressing down on either mounting clip to release the HX2 and try again.
Disconnect
Remove the HX2 from the mount assembly by pushing down on either mounting clip, or both,
until the HX2 mounting bracket disconnects.
Or you can disconnect from one clip, then lift the HX2 up at a 45 degree angle until the other side
disconnects. Lift the HX2 up and away from the mount assembly.
E-EQ-HX2RG-D

Figure 1-15 Mounting Brackets

Figure 1-16 Armband and Hip Flip Mount Assembly and Clips

17
HX2 Reference Guide