J10, J11 - Primary/Secondary Ide Connector; J12 - Floppy Drive Connector; J13 - At Power Connector - DTK PAM-0067V E1 User Manual

3.7 J10, J11 - PRIMARY/SECONDARY IDE
CONNECTOR
These connectors support the provided IDE hard disk ribbon cable.
connecting the single end to the board, connect the two plugs on the other end to
your hard disk.
3.8

J12 - FLOPPY DRIVE CONNECTOR

This connector supports the floppy drive ribbon cable. After connecting the single
end to the board, connect the two plugs on the other end to the floppy drive.
3.9

J13 - AT POWER CONNECTOR

J13 is a 12 pin male connector. Plug the power connector of AT power supply onto
the connector.
Pin
1 Power Good (Orange)
2 +5 VDC (Red)
3 +12 VDC (Yellow)
4 -12 VDC (Blue)
5 Ground (Black)
6 Ground (Black)
Description Pin
7
8
9
10
11
12
Table 9: AT Power Connector
Connector Configuration
Description
Ground (Black)
Ground (Black)
-5 VDC (White)
+5 VDC (Red)
+5 VDC (Red)
+5 VDC (Red)
After
25