J9 - Irda/Fast Ir Connector; J10, J11 - Primary/Secondary Ide Connector; J12 - Floppy Drive Connector - DTK PAM-0067V User Manual

3.8

J9 - IrDA/FAST IR CONNECTOR

J9 is a five pin connector, which use the UART2 as interface for IrDA. You must
also configure the setting through "UART2 Mode" is Integrated Peripheral Setup to
select whether UART2 is used for COM2 or HPSIR/SKSIR. The pin definition is as
following:
3.9 J10, J11 - PRIMARY/SECONDARY IDE
CONNECTOR
These connectors support the provided IDE hard disk ribbon cable.
connecting the single end to the board, connect the two plugs on the other end to
your hard disk.

3.10 J12 - FLOPPY DRIVE CONNECTOR

This connector supports the floppy drive ribbon cable. After connecting the single
end to the board, connect the two plugs on the other end to the floppy drive.
Fig. 14 IrDA/Fast IR Connector
Connector Configuration
After
25