J5 - Internal Modem Ring-In Connector; J7, J8 - Usb Connector; J9 - Irda/Fast Ir Connector - DTK PAM-0067V E1 User Manual

High performance pentium pci mainboard

Table of Contents

Chapter 3

3.4

J5 – INTERNAL MODEM RING-IN CONNECTOR

J5 is a three pin connector which is used to connect the Internal Modem Card's

Ring-in signal to the mainboard. Thus, the mainboard can be wake up from suspend

mode through the Internal Modem Ring-in.

Fig. 12 Internal Modem Ring-in Connector

3.5

Use the 10-way cable to connect the J7, J8 with J5 of GOI-603 extension card.

3.6

J9 is a five pin connector, which use the UART2 as interface for IrDA. You must

also configure the setting through "UART2 Mode" is Integrated Peripheral Setup to

select whether UART2 is used for COM2 or HPSIR/SKSIR. The pin definition is as

following:

Fig. 13 USB Connector

Fig. 14 IrDA/Fast IR Connector

Table of Contents