J3 - Irda/Fast Ir Connector; J4 - Universal Serial Bus Ports 0 & 1; J5, J6 - Primary/Secondary Ide Connector - DTK PAM-0052V User Manual

High performance pentium pci mainboard

Table of Contents

3.3

J3 - IrDA/FAST IR CONNECTOR

J3 is a five pin connector, which use the UART2 as interface for IrDA. You must

also configure the setting through "UART2 Mode" is Integrated Peripheral Setup to

select whether UART2 is used for COM2 or HPSIR/SKSIR. The pin definition is as

following:

3.4

J4 – UNIVERSAL SERIAL BUS PORTS 0 & 1

J4 is a 2x5 pin header for USB0 and USB1 connector, and it is also designed as the

connector for the optional USB extension card.

3.5

These connectors support the provided IDE hard disk ribbon cable.

connecting the single end to the board, connect the two plugs on the other end to

your hard disk.

Fig. 8 IrDA/Fast IR Connector

Fig. 9 USB Connector

Connector Configuration

After

Table of Contents