3.5
J5 - HDD LED CONNECTOR
J5 is usually connected to a HDD LED on front of the system case. If the HDD is in
operation, the indicator lights during operation.
3.6
J6 - KEYLOCK CONNECTOR
J6 is a keylock connector that enables and disables the keyboard.
3.7
J7, J8 - PRIMARY/SECONDARY IDE CONNECTOR
These connectors support the provided IDE hard disk ribbon cable. After connecting the
single end to the board, connect the two plugs on the other end to your hard disk.
3.8
J9 - FLOPPY DRIVE CONNECTOR
This connector supports the floppy drive ribbon cable. After connecting the single end to
the board, connect the two plugs on the other end to the floppy drive.
Fig. 12 HDD LED Connector
Fig. 13 Keylock Connector
Connector Configuration
23