Using Fieldbus Only - CD Automation REVO C 2PH 1100A User Manual

REVO C
2PH from 1100A to 2100A

13.4 Using FieldBus only

The static unit as an option can be ordered with a FieldBus (Ex: profinet).
This option continuously writes the values on the unit keeping them up to date.
Using the field bus it is possible to change the status of the Sw
the communication manual of the respective FieldBus).
Sw = Switch software
S
NOTE:
The parameters written are:
• command table
• reference
• rescaling
if the FieldBus is active but disconnected these values will be forced to 0.
Software switch
from communication
DI
DI Function Con gurated like "Not Used" or di erent from "Enable"
contact with bit 2 of the "Command table" (See
S
Sw
s
Instrument Enable
72
User's manual