Lcd Contast Adjustment; Generator Flywheel Teeth Automatic Adjustment - Smartgen HGM1790N User Manual

4) Press to set the current item, and when the first digit starts blinking, use the same way
that is used for password to enter the set value.
Attention:
a) Please change the controller parameters when generator is in standby mode only (e. g. Crank
disconnect conditions selection, configurable input, configurable output, various delay),
otherwise, shutdown and other abnormal conditions may happen.
b) Serial number of parameters please reference Table1
c) The value of each parameter can be set only within a certain range.
d) Over voltage set value must be higher than under voltage set value, otherwise over voltage and
under voltage condition may occur simultaneously.
e) Over speed set value must be higher than under speed set value, otherwise over speed and
under speed condition may occur simultaneously.
f) Please set the generator frequency value as low as possible when cranking, in order to make
the starter be separated quickly as soon as crank disconnect.
g) Before selecting fuel level sensor type, it is necessary to set a configurable input port type as 8.
h) At any time press

8.2. LCD CONTAST ADJUSTMENT

When genset is in standby status, simultaneously hold and press
enter into LCD contrast adjustment interface, and LCD contrast increases one level every 1s
without releasing buttons. There are 6 levels to select as requirement.

8.3. GENERATOR FLYWHEEL TEETH AUTOMATIC ADJUSTMENT

In manual mode, if crank disconnect conditions select as "2 Speed + Generator Frequency" or
Speed + Generator Frequency + Oil Pressure" (generator frequency and speed are not 0),
controller will automatic adjustment generator flywheel teeth based on gen frequency and poles
when simultaneous press
HGM1790N Genset Controller
HGM1790N GENSET CONTROLLER USER MANUAL
can stop current parameter setting immediately.
and keys.
2017-10-09
and keys for 2s to
Version1.1 Page 22 of 27