C6-Xxxx (Fuser Unit Error) - Samsung MultiXpress K4 Series Service Manual

4.6.8. C6–xxxx (Fuser unit error)
Error Code Error Message
C6-1120 Replace with new fuser unit
C6-1310 Fuser unit is not installed. Install it
► Error Code
C6–1120
► Error message
Replace with new fuser unit
► Symptom
The life of the fuser unit has expired.
► Troubleshooting method
1) Turn the machine off.
2) Replace the fuser
(Refer to 3.2.2.Fuser unit)
3) Turn the machine on.
► Error Code
C6–1310
► Error message
Fuser unit is not installed. Install it.
► Symptom
The fuser unit is not installed or fuser unit connector is not connected properly.
► Troubleshooting method
1) Turn the machine off then on.
2) If the problem persists, turn the machine off again.
3) Open the side cover. Check if the fuser unit is installed. If not, install the fuser unit.
4) If the fuser unit is installed, remove it.
(Refer to 3.2.2.Fuser unit)
5) Check if the fuser draw connector is broken or defective.
6) Install the fuser unit.
7) If the problem persists, replace the fuser
CAUTION
The temperature gets high in the vicinity of the fuser unit. When replacing it, you may get burned. Before replacing
it, make sure that fuser unit has cooled.
Copyright© 1995-2017 SAMSUNG. All rights reserved.
unit(JC91-01163A (220V) /JC91-01164A
unit(JC91-01163A (220V) /JC91-01164A
(110V)).
(110V)).
4. Troubleshooting
Troubleshooting Page
P.4–88
P.4–88
4-88