Table of Contents
Advertisement
► Error Code
H2-6144
► Error message
Finisher is pulled out. Insert it properly
► Symptom
Finisher is pulled out. / Finisher is not installed correctly.
► Troubleshooting method
1) Check if the finisher cable is connected to the copier.
2) Remove and reinstall the finisher.
3) If the problem persists, replace the finisher main board.
Copyright© 1995-2017 SAMSUNG. All rights reserved.
4. Troubleshooting
4-110
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the MultiXpress K4 Series and is the answer not in the manual?