Otto Bock HR51040000-027 Instructions For Use Manual page 17

Adjusting the length of the seat
1) Use an Allen key to loosen the two screws in the adjustment holes on the side of the seat section (see fig. 25).
2) Loosen the hook-and-loop closure of the two overlapping fabric sections in the pelvis area of the back support
(see fig. 26).
INFORMATION: Because the required fabric comes from the back, the bottom tensioning strap of the
back section may have to be loosened depending on how much the seat depth is being adjusted.
3) Pull on the foot section to set the desired length.
4) Retighten both screws when the desired position is reached.
5) Pull the two fabric sections back over each other so they are tight and connect them with the hook-and-loop
closure.
6) Refasten the bottom tensioning strap of the back section if applicable.
Adjusting the fabric cover
To adjust the tension of the cover fabric to the child's needs, loosen the hook-and-loop connections and adjust the
tension of the fabric as needed (see fig. 27).
7 Use
7.1 Using the product
Before using the product, verify that it is securely mounted and in an ergonomically correct position. Inform the
qualified personnel if corrections are required.
1) Set the bathing support to the ergonomically correct position (see page 16).
2) Place the bathing support on a firm, level surface.
INFORMATION: Make sure that the back support height adjustment frame, ratchet joint B (see fig. 15)
and the end of the lower leg support are always in contact with the supporting surface (see fig. 28).
3) Wipe the bathing support dry after every use and allow to air dry. Set the bathing support with the head section
facing down for drying (see fig. 29). The rubber tube protectors prevent slipping and ensure that moisture
drains away through the appropriate holes.
4) The bathing support can be folded to save space after use (see fig. 30).
7.2 Care
CAUTION
Lack of or improper cleaning
Health hazard due to infections, damage to the product due to user error
► Clean the product at regular intervals.
► Do not clean the product with a pressure washer. Doing so can damage the product.
7.2.1 Cleaning
Clean the product regularly depending on the degree of soiling and frequency of use, at least 1x per month:
• Use warm soapy water for cleaning. Add some disinfectant if needed. Carefully dab the product with a damp
cloth or sponge and wipe with a dry, clean cloth.
• The mesh material can be taken off for care and washed at max. +60 °C [+140 °F]. Before washing, fasten the
hook-and-loop fasteners of the straps and place the cover fabric into a pillowcase, which makes unfolding easi­
er after washing and prevents tangling with other laundry.
• Do not use any aggressive cleaners, solvents or hard brushes etc.
• Clean the hook-and-loop closure with a dry brush.
• Allow the product to fully air dry after cleaning.
• Do not expose the product to direct heat (e.g. sunshine, stove or radiator heat, hair dryer).
7.2.2 Disinfection
• Thoroughly clean the product before disinfecting.
• Wipe all parts of the product with a disinfectant.
• Only use colourless water-based disinfectants. Observe the instructions for use provided by the manufacturer.
HR51040000-027, HR51050000-027
Use
17